
38 ■ Watlow MINICHEF 2000 Application 23
3. With [ready] on the display, place the food on the griddle and press the Start/Stop
key(indicated by the rapidly flashing indicator light).
The Start/Stop indicator light will light up. Time will count down on the display.
4. When the cooking cycle is finished, the controller goes into idle and the Start/Stop
key indicator light will switch off. The controller will continue to regulate to the set-
point.
5. Remove the food from the griddle.
6. To repeat cooking, repeat steps 2 through 5.
Run a Menu (without preheat feature)
This procedure describes how to run the menu when the preheat feature is inactive
(when the [Ready] parameter in the [SetUp] function of the Configuration Mode is set
to [```no]).
1. Set the menu as shown earlier.
2. With [`idle] or time of day on the display, press the Start/Stop key.
3. The Start/Stop indicator light will light up. Time will count down on the display.
4. When the cooking cycle is finished, the controller goes into idle and the Start/Stop
key indicator light will switch off. The controller will continue to regulate to the set-
point.
5. Remove the food from the griddle.
6. To repeat cooking, repeat steps 2 through 5.
Adjust a Menu While Cooking
You can adjust the temperature and time settings during the cooking and hold
sequences by performing the actions shown under “Set the Menu” earlier in this section.
DE
C
F
MINICHEF 2000
[`idle]
Edit Accept
Back-UpExit
DE
C
F
MINICHEF 2000
[`0009]
Edit Accept
Back-UpExit
B
DE
C
F
MINICHEF 2000
[`idle]
Edit Accept
Back-UpExit
G H
A
AB
GH
AB
GH
STEADY
ON
SLOW
FLASH
DE
C
F
MINICHEF 2000
[``EnD]
Edit Accept
Back-UpExit
B
DE
C
F
MINICHEF 2000
[`idle]
Edit Accept
Back-UpExit
G H
AAB
GH
RAPID FLASH
SLOW FLASH
DE
C
F
MINICHEF 2000
[ready]
Edit Accept
Back-UpExit
DE
C
F
MINICHEF 2000
[`0009]
Edit Accept
Back-UpExit
B
DE
C
F
MINICHEF 2000
[`idle]
Edit Accept
Back-UpExit
G H
A
AB
GH
AB
GH
STEADY
ON
RAPID
FLASH
SLOW
FLASH
DE
C
F
MINICHEF 2000
[``EnD]
Edit Accept
Back-UpExit
B
DE
C
F
MINICHEF 2000
[`idle]
Edit Accept
Back-UpExit
G H
AAB
GH
RAPID FLASH
SLOW FLASH
Komentáře k této Příručce