Watlow SpecView from Watlow Uživatelský manuál stáhnout pdf (Strana 32)

SpecView from Watlow  32  Watlow Addendum

2) With SpecView

running, to enter the

configuration mode,

from the File menu

choose

Configuration Mode.

3) Click to open the

Variables list.

4) Select the instrument.

5) Click Properties.

6) In the Address field

set the decimal places

corresponding to the

controller setting

0 for whole numbers,

1 for tenths,

2 for hundredths,

3 for thousandths

4 for ten-thousandths:

• For Modbus RTU

protocol set the

number after the

comma.

• For Modbus TCP or

Anafaze/AB protocols

set the number after

the second comma.

7) Click Rename Only.

Modbus RTU: the decimal setting is after the comma

Modbus TCP: the decimal setting is after the second comma

8) To save the GDW:

• From the File menu,

choose Save.

Note: The possible decimal settings may depend on other controller settings such as the sensor type.

Not all parameters are affected by the decimal setting.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Žádné komentáře

Watlow SpecView from Watlow Uživatelský manuál Strana 32