Watlow SpecView from Watlow Uživatelský manuál stáhnout pdf (Strana 17)

SpecView from Watlow  17  Watlow Addendum

8) For the Port to

which the

controllers are

attached, choose the

appropriate protocol

driver in Protocol.

See the table below.

Note: If there are controllers

on the same port that

require different drivers,

you will need to repeat

steps 8 to 10 for each

protocol.

9) Click Start Scan.

For this Controller… Choose this Protocol

Driver…

Notes

EZ-ZONE PM, RM or ST

Watlow EZ-ZONE

Standard Bus

SERIES 96, 97, SD

MICRODIN,

POWER SERIES,

986, 987, 988, 989

Watlow Modbus

SERIES F4 Ramping

Watlow Modbus

Watlow F4 Programmer

For the SERIES F4 Profiling controller, scan twice,

once with each protocol driver. Add the F4 Cascade

instrument manually if desired. See

Manually Set up

or Modify a Modbus RTU, 485 or 232 Network

page 22.

16CLS, 16MLS,

CLS216, MLS316

Anafaze 16 Loop

CLS200 and MLS300 Standard and Ramp/Soak

firmware options. For controllers with Ramp/Soak to

add the Anafaze Profile Status and the desired

Anafaze Profile instruments. See

Manually Set up or

Modify a Modbus RTU, 485 or 232 Network on page

22.

32MLS, MLS332

Anafaze 32 Loop

8CLS, CLS208

4CLS, CLS204

Anafaze 8 Loop

32MLS (Anafaze protocol)

Anafaze/AB

Scan with the Watlow F4 Programmer driver only if the F4 programmer option is enabled.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Komentáře k této Příručce

Žádné komentáře

Watlow SpecView from Watlow Uživatelský manuál Strana 17

Komentáře k této Příručce

Související produkty a manuály pro Senzory Watlow SpecView from Watlow