Watlow Silver Series Addendum Uživatelský manuál stáhnout pdf (Strana 10)

Silver Series OIT  10  Watlow Addendum

Data Types

The Silver Series OIT’s Modbus drivers support a variety of data types. The Watlow manuals specify

the data type of each parameter. However the terminology is not precisely the same. The table below

correlates the data types indicated in the Watlow documentation with the data types you should select

when configuring a screen object in EasyBuilder5000.

EZ-ZONE User’s

Manuals

EZ-ZONE ALL

Modbus List

EasyBuilder5000

uint

Enumeration,

unsigned 8-bit,

Event,

unsigned 16-bit

16-bit Unsigned

dint

signed 32-bit

32-bit Signed

float

IEEE Float

32-bit Float

Important Things to Know

Note: Make sure the Modbus Word Order is set to Word Low High in the controller.

That is the setting that works with the Silver Series OIT.

Note: Examples in this manual use the map 1 addresses. If the controller’s Data Map is

set to 2, the examples may not work.

Caution: When you use a multi-state switch object to set an enumerated parameter in a

controller, each time the user clicks the switch, the setting selected by the switch

is sent to the controller. When it is desirable to go directly from one setting to

another without intermediate settings, use a set word object or an option list to

set the parameter instead.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Žádné komentáře

Watlow Silver Series Addendum Uživatelský manuál Strana 10