Watlow Relay Interface Board Uživatelský manuál Strana 8

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 22
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 7
Relay Interface Board Installation Guide
4
Installation
These instructions assume the controller has previously been installed.
Tools Needed
Four, #6 screws
Screwdriver
Mounting
1. Choose a mounting location large enough to accommodate the RIB, the I/O
board or boards, the ribbon cable or cables and wires that connect them.
2. Place the RIB in a suitable location to be mounted and use a pencil to trace
around the plastic standoffs or use the dimension diagram in Figure 1 to posi-
tion the mounting holes.
3. Drill and tap #6-32 holes in the marked locations.
4. Place the Relay Interface Board in the mounting location and insert the #6
screws in the plastic standoffs.
5. Tighten the screws.
Zobrazit stránku 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Komentáře k této Příručce

Žádné komentáře