Watlow Relay Interface Board Uživatelský manuál stáhnout pdf (Strana 10)

Relay Interface Board Installation Guide

Wiring

These instructions explain how to connect the RIB to the Watlow Anafaze Controller

and to the I/O board.

Ribbon Cable

Connect the ribbon cable to the controller. Plug the other end of the ribbon cable into

the header labeled J1 on the Relay Interface Board. The red stripe on the ribbon cable

should line up with Pin 1 on the board.

Plug one end of the I/O board ribbon cable into the I/O board and the other end into

the RIB. See

Tables 3, 4 and 5

for connection information. Repeat for each I/O board

installation.

Use a felt-tip pen to write the cable’s name and number in the white box next to the

header.

I/O Board Terminals

Refer to

Tables 3, 4 and 5

for the controller signals that correspond to each I/O

module.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Žádné komentáře

Watlow Relay Interface Board Uživatelský manuál Strana 10