Watlow MINICHEF Timer Applications Uživatelský manuál stáhnout pdf (Strana 14)

12 ■ Watlow MINICHEF 2000 Application 25

3 When the timer has completed [``end] will appear on the display, the Start/Stop

key indicator light will flash rapidly, and an alarm will sound until the Start/Stop

key is pressed to acknowledge and shut off the timer.

4. To run the timer again repeat steps 1 thru 3.

Note: The controller will not respond if Time is set to 0.

Pause a Menu

While the timer is counting down you can pause it by pressing the Pause key. The

Pause key indicator light will flash rapidly until you press it again to resume the count-

down.

Cancel a Menu

To cancel the active menu, press and hold the Start/Stop key for approximately 2 sec-

onds.

Event Outputs

When [etype] / [t`OUt] in the Configuration Mode is set to [``yes], Event Output 2

is on during the countdown of the timer.

Errors

The controller will alert you to errors if they occur. Errors are critical problems that

shut down the unit. If an error occurs, an error message will appear on the display. You

should switch off the power and call for service.

See the Appendix in the Hardware & Software Setup Guide for a summary of errors.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Žádné komentáře

Watlow MINICHEF Timer Applications Uživatelský manuál Strana 14