Watlow LogicPro Uživatelský manuál stáhnout pdf (Strana 252)

Chapter 15: Downloading & Monitoring LogicPro User’s Guide

236 Watlow Anafaze Doc.# 28002-00 Rev 3.00

NOTE! The port is identified when setting up a resource.

The port must be set correctly before building and

compiling executable code for a resource. See

Editing a Resource on page 36 in order to verify or

change the communications port selection.

4. Select Execution menu.

5. Select Build All and Run

– or –

Click on the [Build All and Run] tool. This will build

the runtime executable, download it to the target control-

ler and run your logic control program.

6. The Downloading dialog box will open during the

download displaying transfer statistics and any errors en-

countered.

7. You can start and stop the run time executable by click-

ing the [Start Executable] tool

– or –

[Terminate] tool.

Alternatively, if a runtime executable has already been built:

1. If downloading to a PPC-2000 controller:

a. Set the control mode for each channel to Off.

b. Set each alarm to Disabled.

2. If downloading to a CPC400 controller, note any alarms.

Once downloading commences, all alarms are automati-

cally acknowledged.

CAUTION! Input readings during downloads are not accurate

and may vary widely due to allocation of CPU re-

sources for downloading. Stopping closed loop

control and disabling alarms ensures that outputs

remain off during download.

3. Select the Execution menu.

4. Select Download and Run

– or –

Click the [Download and Run] tool on the Standard

toolbar to just download the runtime executable to the

controller and run your logic control program.

1 2 ... 247 248 249 250 251 252 253 254 255 256 257 ... 295 296

Žádné komentáře

Watlow LogicPro Uživatelský manuál Strana 252